[HACK] Sero 7 Pro Inductive Charging Pad

Sero 7 Pro modded with a Verizon Wireless Inductive Charger pack from a HTC Thunderbolt.

Step 1:
Solder wires to the + and - of the back of the battery shell. Red is positive 5v and Black is Ground


Step 2:
Remove the inductive module from the back shell


Step 3:
CAREFULLY PEAL BACK THE PCB AND INDUCTIVE COIL
SERIOUSLY BE CAREFUL IT IS STUCK WITH STICKY TAPE
YOU CAN BEND THE COIL PORTION BUT NOT THE PCB.


Step 4:
Solder the points for positive and negative to the points in the picture below


Final Step:
Position the module exactly like you see I did below. It will overhang onto the safe tape portion of the PCB and allow a nice flush mount of the back of the Sero 7 Shell when you put it back on

Attached Thumbnails