Hello Community,
Recently a couple of flashes turned my device into a living nightmare where I lost about seventeen partitions from the device which took me weeks to put back together, however I'm experiencing a crutical flaw within the ADB software how as there is no way to configure the "head" (in this case shows as "four" when I want to switch it as "one") within the clyinders and units measuring on partition blocks.
Can someone, give me some insight with ADB knowledge how to change the head #'s?
(Using fdisk /dev/block/mmcblk0)
Recently a couple of flashes turned my device into a living nightmare where I lost about seventeen partitions from the device which took me weeks to put back together, however I'm experiencing a crutical flaw within the ADB software how as there is no way to configure the "head" (in this case shows as "four" when I want to switch it as "one") within the clyinders and units measuring on partition blocks.
Can someone, give me some insight with ADB knowledge how to change the head #'s?
(Using fdisk /dev/block/mmcblk0)